Upper cavity dead, lower one working perfectly. He separated what the panel was claiming from what the oven was actually doing, which sounds obvious but nobody else had. Element, not the board I had been quoted for elsewhere.
Drusilla W. · Beverly
North Shore · 01960
Appliance repair in Peabody
Inland enough to escape the worst of the salt, with a housing stock that is mostly post-war single family and straightforward to work in.
- Area
- North Shore
- Service call
- $95, credited
- On site
- 8:00 am – 8:00 pm, seven days
- Dispatch
- Answered 24/7
The wider area
What the North Shore has in common
Salt air is the variable that separates the North Shore from everywhere else we work. Condenser coils and exposed fasteners corrode faster within a mile of the water, and a coil that would last a decade inland does not.
What we repair in Peabody
- Refrigerator Repair Freestanding and integrated refrigeration across every brand we carry.
- Built-In Refrigerator Repair The 36 to 48 inch built-ins that a kitchen was designed around.
- Column Refrigerator Repair Separate refrigerator and freezer columns, usually installed as a pair.
- Undercounter Refrigerator Repair Islands, bars and butler pantries — the hardest thermal positions in the house.
- Freezer Repair Freezer drawers, columns and the freezer half of a built-in.
- Ice Maker Repair Built-in ice makers and the ice section of a refrigerator.
- Wine Cooler Repair Dual-zone cabinets, wine columns and undercounter wine units.
- Range Repair Professional gas, dual-fuel and induction ranges.
Repair bands
What the repair itself costs
| Repair | Typical range |
|---|---|
| Door gasket or seal replacement | $290 – $780 |
| Evaporator or condenser fan motor | $300 – $640 |
| Defrost heater, thermostat or sensor | $300 – $740 |
| Ice maker, water valve or supply line | $300 – $650 |
| Electronic control board | $480 – $860 |
| Compressor or sealed-system repair | $1,040 – $2,220 |
What people said afterwards
4.9out of 5
from 956 reviews across Greater Boston
Ours is boxed into cabinetry that was built around it, and I was worried about damage getting it out. He worked out the access first, took the panel off carefully, and put everything back exactly as it was. Nothing marked.
Clementine V. · Brookline
Heating at one end of the drawer only, which I had assumed meant a new drawer. Element had failed along part of its length. Straight swap and it heats evenly again. He was in and out in well under an hour.
Constance O. · Lexington
Nearby